Removing Driveline - Ca20 And Ca25 - MacDon CA20 Service Manual

2.1.2 Removing Driveline – CA20 and CA25
WARNING
To avoid injury or death from unexpected start-up of machine, always stop engine and remove key from ignition before
leaving operator's seat for any reason.
1. Remove the two nuts (A) securing the shield (B) to the
gearbox.
2. Slide the shield (B) over the driveline shield to expose the
quick disconnect on the gearbox. Do NOT disconnect the
tether (C), if equipped.
3. Pull the quick disconnect collar to release the driveline
yoke, and pull the driveline off the shaft.
4. Slide the shield (B) off the driveline.
5. Rotate the disc (A) on the adapter driveline storage hook,
and remove the driveline from the hook.
214923
INSTALLATION INSTRUCTIONS
Figure 2.4: Adapter End of Driveline
A
Figure 2.5: Combine End of Driveline
7
B
A
C
Revision A