MacDon CA20 Service Manual page 18

3. Slide shield (A) over driveline (B).
4. Position the driveline quick disconnect onto the float
module gearbox shaft, pull back the collar, and slide it onto
the shaft until it locks in place. Release the collar.
5. Position shield (A) on the gearbox and secure with bolts (C).
6. For drivelines equipped with safety chains, attach chain (D)
at the module end to chain (E) on the shield.
214923
INSTALLATION INSTRUCTIONS
A
E
Figure 2.15: Float Module End of Driveline
12
C
B
D
Revision A