Removing Driveline; Removing Driveline - Fm100 - MacDon CA20 Service Manual

2.1 Removing Driveline

Refer to the correct topic below for your model:
• 2.1.1 Removing Driveline – FM100, page 6
• 2.1.2 Removing Driveline – CA20 and CA25, page 7
2.1.1 Removing Driveline – FM100
WARNING
To avoid injury or death from unexpected start-up of machine, always stop engine and remove key from ignition before
leaving operator's seat for any reason.
1. Shut down the combine, and remove the key from the ignition.
3. Loosen two bolts (C), and remove driveline shield (B).
4. Detach safety chain (A) (if equipped) from chain (D) on the
driveline shield. Do NOT disconnect chain (D).
5. Pull the quick disconnect collar to release the driveline
yoke, and pull the driveline off the gearbox shaft.
6. Pull driveline collar (A) away from power take-off (PTO)
support (B). Slide yoke (C) off support bracket (B), and
release collar (A).
214923
INSTALLATION INSTRUCTIONS
Figure 2.2: Float Module End of Driveline
Figure 2.3: Combine End of Driveline
6
C
B
C
D
C
A
A
B
Revision A