Lan - D-Link DAP-1155 User Manual

DAP-1155 Wireless N150 Access Point & Router
User Manual

LAN

To configure the access point's local interface, proceed to the Net / LAN page.
If needed, edit the basic settings of the local interface.
Parameter
IP Address
Netmask
When needed settings are configured, click the Apply button.
In the DHCP server section, you can configure the built-in DHCP server of the access point.
Parameter
Mode
Figure 76. Basic settings of the local interface.
The IP address of the access point in the local subnet. By default, the
following value is specified: 192.168.0.50.
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
Figure 77. The section for configuring the DHCP server.
An operating mode of the access point's DHCP server.
Enable: the device assigns IP addresses to clients automatically in
accordance with the specified parameters. When this value is
selected, the DNS Relay, Start IP, End IP, and the Lease time
fields are displayed on the page.
Disable: the device's DHCP server is disabled, clients' IP addresses
are assigned manually.
Relay: an external DHCP server is used to assign IP addresses to
clients. When this value is selected, the External DHCP server IP
field is displayed on the page.
Page 92 of 158
Description
Description
Configuring Device