D-Link DAP-1155 User Manual page 87

DAP-1155 Wireless N150 Access Point & Router
User Manual
Figure 74. The page for creating a new PPTP + Static IP connection. The IP section.
Parameter
IP Address
Netmask
Gateway IP address
Primary DNS server/
Secondary DNS server
Isolate connection
Enable RIP
Enable IGMP Multicast
NAT
Firewall
Ping
For PPTP + Static IP and L2TP + Static IP types
Enter an IP address for this WAN connection.
Enter a subnet mask for this WAN connection.
Enter an IP address of the gateway used by this WAN connection.
Enter addresses of the primary and secondary DNS servers in the
relevant fields.
When the checkbox is selected, the access point uses an alternate
routing table for this connection. Select the checkbox only when
your ISP requires this.
Select the checkbox to allow using RIP for this connection.
Select the checkbox to allow multicast traffic from the external
network (e.g. video streaming) to be received.
Select the checkbox if you want one WAN IP address to be used for
all computers of your LAN.
Select the checkbox to enable protection against ARP and DDoS
attacks.
Select the checkbox to allow the access point to answer ping
requests from the external network through this connection. For
security reasons, it is recommended not to select this checkbox.
Page 87 of 158
Description
IP
Configuring Device