Mower Brake - CanyCom MASAO CMX227 Operator's Manual

Notch
Washer
5347M-0508-011E
Lock Nut
Turnbuckle
5347M-0508-020E

Mower Brake

• Never place any part of body under cutting blade shield when mower is running.
• Do not allow bystanders to come near machine when inspecting mower brake.
Ride on machine when testing mower brake.
Maintenance
4.
NOTE
• There are two sets of notches. Refer to the
illustration on the left.
5.
Spring
6.
NOTE
• If the washer cannot be aligned to the
notches by adjusting the turnbuckle (V-belt
tension cannot be set within the specified
range), the V-belt needs to be replaced.
Contact your CANYCOM representative for
replacement.
7.
-75-
Visually inspect if the washer that holds the
spring is aligned with the right side of the
notches on the plates as shown.
If the washer is not aligned with the notches,
loosen the lock nut and adjust the turnbuckle.
Tighten the lock nut.
Reinstall the rear cover, engine hood, and
rear bumper.
5