Programmable Options - Infinite Peripherals Linea Pro 6 User Manual

For iphone 6/6s

Hide thumbs Also See for Linea Pro 6:

User manual (32 pages)

How to use (4 pages)

Quick start manual (2 pages)

Table Of Contents

Table of Contents

USER MANUAL — LINEA PRO 6

Programmable Options

Configure these optional settings via the SDK.

Charging Current

Charging current may be set to 500mA (default) or 1000mA.

Set Charging

The Linea Pro 6 can charge the iPhone using its internal battery by enabling the "setCharging" setting. When the Linea Pro 6 battery is above 20%, it will

then start to charge the iOS device battery.

Enable Scan Button

Select the Enable Scan button in the SDK.

Scan Mode

Linea Pro 6 supports the following scan modes:

Single Scan

Scanning a single barcode by pressing and releasing either Scan button.

Multi Scan

Scanning multiple barcodes by pressing and holding either Scan button.

Motion-Detect

Scanner is activated automatically when barcode is placed near the barcode engine.

Multi-Scan without Duplicates

Scanning multiple barcodes without duplicates.

Pass-Through Sync

When enabled and the USB cable is plugged in, the iOS device is synced with a Windows computer or an Apple MacOS.

When syncing is required, enable the Pass-Through Sync setting in the SDK. When this setting is disabled and the USB cable is plugged in, the Linea Pro 6

only charges, but does not scan.

To use the scanner again, the USB cable must be removed.

Idle Time

Default setting: 5400 seconds (90 minutes).

Table of Contents