Programmable Options; Charging Current; Set Charging; Enable Scan Button - Infinite Peripherals Linea Pro Rugged User Manual

User Manual — Linea Pro Rugged for iPod touch

Programmable Options

Configure these optional settings via the SDK.

Charging Current

Charging current may be set to 500mA (default) or 1000mA.

Set Charging

The Linea Pro Rugged can charge the iPod using its internal battery by enabling the "setCharging" setting. When the Linea Pro
Rugged battery is above 20%, it will then start to charge the iOS device battery.

Enable Scan Button

Select the Enable Scan button in the SDK.

Scan Mode

Linea Pro Rugged supports the following scan modes:
Single Scan
Scanning a single barcode by pressing and releasing either Scan button.
Multi Scan
Scanning multiple barcodes by pressing and holding either Scan button.
Motion-Detect
Scanner is activated automatically when barcode is placed near the barcode engine.
Multi-Scan without Duplicates
Scanning multiple barcodes without duplicates.

Pass-Through Sync

When enabled and the USB Type-C cable is plugged in, the iOS device is synced with a Windows computer or an Apple
MacOS.
When syncing is required, enable the Pass-Through Sync setting in the SDK. When this setting is disabled and the USB cable
is plugged in, the Linea Pro Rugged only charges, but does not scan.
To use the scanner again, the USB Type-C cable must be removed.
Idle Time
Default setting: 5400 seconds (90 minutes).
11