The Mia ® & Miaplus ® Controls - BainUltra THERMOMASSEUR Owner's Manual

THE MIA & MIA PLUS
®
MIA
®
REQUIRED TOOLS
1 Fine teeth jigsaw
2 Drill
3 1/4 in. drill bit
LOCATION
Determine the most convenient location, on
either the wall or the deck, to install the control
module or consult the bath's specifications
sheet for the suggested location. To avoid drill-
ing in an air intake zone or an electric compo-
nent, always check under the deck before drill-
ing. If you have to install the control to the wall,
remove the mounting bracket wing nuts and the
protective film of sticker behind the control. You
can add a silicone bead to secure it.
DRILLING
Refer to the drilling template on the last page for
the location and diameter of the holes.
KEYPAD INSTALLATION
1 Push wiring through drilled holes.
2 Remove protective film from watertight
seal.
3 Secure keypad into place on either the
deck or the wall by using 2,
8-32 x 1" studs and 2 wing nuts.
4
T ighten sufficiently to insure seal is
airtight.
WARNING • If control was not factory-installed, it will be attached to the turbine.
www.bainultra.com
Some products, specifications, and services mentioned in this manual are described in pending patent applications or are protected by patents.
CONTROLS | OWNER'S MANUAL
®
& MIAPLUS CONTROLS INSTALLATION
®
THERMOMASSEURS
39