Balneo - Cella Installation - BainUltra THERMOMASSEUR Owner's Manual

INSTALLATION INSTRUCTIONS | OWNER'S MANUAL
1. BATH SITE
1-1 O nce the floor has been finished and
is perfectly level, determine the exact
location of the ThermoMasseur
M ark the following on the floor:
a) position of the four feet;
b) holes to be drilled for the drain and
air intake for the turbine.
1-2 Drill the four holes for the feet with
a 3/16'' drill bit and the drain and air
intake openings with a 2'' hole saw.
2. INSTALLATION
2-1 I nstall the drain and overflow set on
the bath and the first section of the
air intake pipe (1 1/2'' ABS) under the
floor. Cover the ABS pipe with pipe con-
cealer (included). For Geysair-equipped
baths, also run the water hose and wir-
ing through the pipe concealer.
2-2 Once the ThermoMasseur
with piping installed in the floor, secure
the four feet with screws and washers
provided. (A-2)
2-3 For Geysair-equipped baths, connect
the Geysair electrical wire supplied
with the male connector with the
turbine cable equipped with the female
connector. Test for grounding continu-
ity between the bath grounding termi-
nal and the bath power supply.
Failure to perform the grounding
continuity test could result in serious
personal injury. See page 18
image .
2-5
IMPORTANT
WARNING
www.bainultra.com
Some products, specifications, and services mentioned in this manual are described in pending patent applications or are protected by patents.
.
®
is in place
®
• Do not remove the protective plastic film from the bath and place a drop-cloth in the ThermoMasseur
during installation to protect the acrylic.
• The ThermoMasseur ® must be secured to the floor.
• Balneo baths cannot be drilled for faucet installation. Faucets must be freestanding or
®
wall-mounted models.
BALNEO
Cella 6636 & 7236
5
1/2
Cella 6036
Cella 6636 & 7236
2-1 2-1
2-1 2-1
- CELLA
®
INSTALLATION
"
[14 cm]
2 "
3/4
[7 cm]
®
19