Important Instructions On Use; Intended Use; Introduction; Use And Application Cases - Bosch Rexroth IndraControl S67 Series Application Description

DOK-CONTRL-S67DO8M122A-AP03-EN-P
Rexroth IndraControl S67 Digital Module 8 Outputs – 2.0 A (4×M12)
2

Important Instructions on Use

2.1

Intended Use

2.1.1

Introduction

2.1.2

Use and Application Cases

The Rexroth products represent state-of-the-art developments and manufac‐
turing. The products are tested prior to delivery to ensure operating safety
and reliability.
The products may only be used as intended. If the products are not used as
intended, situations causing personal injury as well as material damage can
occur.
Rexroth shall not be liable for damages resulting from unintended
use. In such cases, the guarantee and the right to payment of
damages resulting from unintended use are forfeited. The user
alone carries all responsibility of the risks.
Before using Bosch Rexroth products, the following requirements must be
met to ensure intended use of the products:
● Personnel who in any way, shape, form or use one of our products must
first read and understand the relevant safety instructions and be familiar
with the intended use of the products
● If the product takes the form of hardware, they must remain in the origi‐
nal state, in other words, no structural changes are permitted. The de‐
compilation of software products or the alteration of source codes is not
permitted
● Do not install or operate damaged or faulty products
● Ensure that the products have been installed as described in the rele‐
vant documentation
The S67-DO8-M12-2A module outputs digital signals specified by a parent
control (e.g., programmable coupler).
The S67-DO8-M12-2A module cannot be used to control safety purpose
functions, i.e., the S67-DO8-M12-2A module cannot be a functional compo‐
nent of a safety function.
The digital outputs of the S67-DO8-M12-2A module are feedback-free and
thus not affected by internal groups of potentials. The module can only be
used in a safety circuit together with a safety control device (with diagnostic
function) or with other feedback-free modules. The module is not a safety-ori‐
ented component. Refer to
Safety Applications" on page
The S67-DO8-M12-2A module shall only be used in combination with a field
bus coupler and I/O modules of the IndraControl S67 series.
The S67-DO8-M12-2A module was developed for applications requiring the
degree of protection IP 67 (NEMA type 6, 6P).
Bosch Rexroth AG
Important Instructions on Use
chapter 12 "Using Feedback-Free Module in
53.
9/69