Removing Module From Profile Adapter; Connecting Module; Disposal - Bosch Rexroth IndraControl S67 Series Application Description

52/69 Bosch Rexroth AG
Maintenance and Service
11.2.5

Removing Module from Profile Adapter

11.2.6

Connecting Module

11.3

Disposal

Rexroth IndraControl S67 Digital Module 8 Outputs – 2.0 A (4×M12)
A
Fig. 11-1: Removing module with mounting rail adapter from mounting rail
If the S67-DO8-M12-2A module is mounted on a profile adapter, proceed
with the removal as follows:
1. Disconnect the power supply from the device the S67-DO8-M12-2A
module is mounted to before removal.
2. Unscrew the screws the nuts are fastened on and remove the S67-DO8-
M12-2A module from the profile rail of the system.
3. Unscrew the screws that connect the S67-DO8-M12-2A module with the
profile adapter.
To connect the new S67-DO8-M12-2A module, proceed as described in the
following chapters:
● chapter 5 "Mounting Module" on page 23
● chapter 6 "Connecting Data and Supply Cables" on page 31
● chapter 7 "Commissioning" on page 37
Depending on the type of field bus coupler used, the parameters of the previ‐
ous S67-DO8-M12-2A module are transferred to the new module if necessa‐
ry (see also chapter 9.5 "Automatic Storage of System Parameters" on page
45).
Do not dispose the IndraControl S67 components with the household waste.
Comply with the regulations. You can also contact a certified waste disposal
company.
DOK-CONTRL-S67DO8M122A-AP03-EN-P
B C