Mounting Spacer In Case Of Compact Arrangement - Bosch Rexroth IndraControl S67 Series Application Description

28/69 Bosch Rexroth AG
Mounting Module
5.8

Mounting Spacer in Case of Compact Arrangement

Rexroth IndraControl S67 Digital Module 8 Outputs – 2.0 A (4×M12)
Using the spacer, a sufficient mounting distance can be achieved when di‐
rectly mounting the IndraControl S67 components. Gaps where dirt can accu‐
mulate are thus prevented. In addition, it is possible to optimize the cable
routing of the actuators. Thus, two fastening lugs each for cable ties are loca‐
ted on the spacer.
1. Disconnect the power supply from those devices on which the S67-
DO8-M12-2A module is to be mounted.
2. To prevent the IndraControl S67 components from falling out when
mounted overhead, the spacer can only be moved to the intended open‐
ings of the S67-DO8-M12-2A module from below. To connect both com‐
ponents, place the S67-DO8-M12-2A module on the spacer or push the
spacer from the bottom into the S67-DO8-M12-2A module.
3. Fasten the attached components on a flat surface by fastening the S67-
DO8-M12-2A module to the grounded system frame or to another
grounding point via the mounting holes using two M4 screws.
Fig. 5-6: Attaching spacer at module
4. When attaching further IndraControl S67 components, only one
IndraControl S67 component connected with a spacer can be attached
and screwed to the preceding component due to the mounting direction.
The last IndraControl S67 component is fastened without a spacer.
DOK-CONTRL-S67DO8M122A-AP03-EN-P
DO8-2A
SB
F
6
X
4
4
X
7
3
2
5
X
2
0
X
3
1
1
24V
U U
LS A