Fastening Module With Profile Adapter To Profile Rail; Replacing Labeling Fields - Bosch Rexroth IndraControl S67 Series Application Description

DOK-CONTRL-S67DO8M122A-AP03-EN-P
Rexroth IndraControl S67 Digital Module 8 Outputs – 2.0 A (4×M12)
5.6.2

Fastening Module with Profile Adapter to Profile Rail

5.7

Replacing Labeling Fields

To fasten the S67-DO8-M12-2A module to a profile rail of the system, two
slot nuts are required with one screw each (thread length has to match the
profile).
1. Disconnect the power supply from those devices on which the S67-
DO8-M12-2A module is to be mounted.
2. Insert the two screws into the holes above and beneath the fastened
S67-DO8-M12-2A module on the profile adapter.
3. Fasten an appropriate slot nut on each of these screws.
4. Insert the profile adapter with the attached S67-DO8-M12-2A module in‐
to the profile rail of the system. Position the profile adapter and tighten
the screws.
The module labeling plate and the labeling strip are provided upon delivery.
Remove the protective cover when labeling the labeling strip. Proceed as fol‐
lows:
1. Press the slot screwdriver (maximum slot width: 3 mm) into the small
opening under the labeling strip cover (12) and lever it up.
2. Remove the labeling strip cover.
3. Label the labeling strip with a waterproof pen.
4. Insert the labeling strip cover again and press it firmly in place.
If the module labeling card (10) is to be replaced, proceed the steps previous‐
ly described. New module labeling cards are available from Bosch Rexroth as
accessories.
1 0
4
X
3
5
0
X
1
1
Fig. 5-5: Replacing labeling fields
Bosch Rexroth AG
DO8-2A
SB SB
F
6
12
X
4
7
2
X
2
3
24V 24V
U U U U
LS LS A A
27/69
Mounting Module