Fastening Module With Mounting Rail Adapter To Mounting Rail - Bosch Rexroth IndraControl S67 Series Application Description

DOK-CONTRL-S67DO8M122A-AP03-EN-P
Rexroth IndraControl S67 Digital Module 8 Outputs – 2.0 A (4×M12)
5.5.2

Fastening Module with Mounting Rail Adapter to Mounting Rail

Fig. 5-2: Mounting on the mounting rail adapter
For a clear figure, the mounting rail adapter in the figure below is shown with‐
out the S67-DO8-M12-2A module.
When mounting the S67-DO8-M12-2A module to a mounting rail (35 x 7.5
rail) using a mounting rail adapter, proceed as follows:
1. Disconnect the power supply from those devices on which the S67-
DO8-M12-2A module is to be mounted.
2. Position the S67-DO8-M12-2A module to the edge of the mounting rail
(51) with the two notches (50).
3. Press the lower side against the lower mounting rail edge until the latch
(52) is engaged.
For vertical mounting of the mounting rail or when vibrations or
shock occur, use the end clamps "SUP-M01" or "SUP-M01 AL"
for stabilization (see
Bosch Rexroth AG
chapter 13.5 "End Clamp" on page
25/69
Mounting Module
61).