Mounting Module; General Information; Mounting Notes; Required Tools And Accessories For Mounting - Bosch Rexroth IndraControl S67 Series Application Description

DOK-CONTRL-S67DO8M122A-AP03-EN-P
Rexroth IndraControl S67 Digital Module 8 Outputs – 2.0 A (4×M12)
5

Mounting Module

5.1

General Information

5.2

Mounting Notes

5.3

Required Tools and Accessories for Mounting

The S67-DO8-M12-2A module can be fastened directly to the system using
screws. It can also be mounted on a mounting rail using an adapter or fas‐
tened to a profile rail using a mounting profile.
To mount on a flat surface, Bosch Rexroth provides spacers as mounting aid.
The spacers can be inserted between the IndraControl S67 components.
This provides sufficient mounting distance for compact direct mounting and
prevents gaps where dirt can accumulate. A cable tie can be fastened
through each of two eyes in the spacer, which together serve as strain relieve
of the actuator cables.
Always follow the subsequent instructions:
● Disconnect the power supply from the system before mounting.
● The maximum drilling hole diameter for the fastening holes of module
must not exceed 4 mm. Otherwise, there may be no full contact with the
PE socket of the S67-DO8-M12-2A module and correct shielding is not
possible.
● To protect the S67-DO8-M12-2A module from tensile forces, do not
bridge spaces with that module
● Screw the S67-DO8-M12-2A module only on flat contact surfaces to
protect it from warping
● Ensure that the connectors are not soiled during mounting. Dirt dam‐
ages the contacts. Corrosion can be caused
● In order not to damage the S67-DO8-M12-2A module, do not mount it in
shear areas of moving system components
● Provide sufficient potential equalization in the system
● Use all fastening holes to mount the S67-DO8-M12-2A module to the
system so that all FE connections are on a ground potential.
Depending on the mounting type, the following tools are required:
● Screwdriver for M4 fastening screws
● Drilling machine to pre-drill the fastening holes to mount on the system
for the S67-DO8-M12-2A module and, if applicable, for the imperforated
mounting rails
● M4 thread cutter (tap or tap set)
The Bosch Rexroth accessory components listed below are required for
mounting. The corresponding ordering numbers are listed in
cessories" on page 59.
● Mounting rail adapters including fastening screws and perforated or
non-perforated mounting rails (TS 35 x 7.5 rail) acc. to EN 60715
or
● Profile adapters including fastening screws
● Spacer (optional)
Bosch Rexroth AG 23/69
Mounting Module
chapter 13 "Ac‐