Selector Switch 2; Reset -Overload; Timer; Add Mix" Indicator Light - ELECTRO FREEZE SOFT SERVE TWIST SL500 Operator's Manual

ELECTRO FREEZE Soft Serve Model SL500
5 Operator Controls (
5.2

Selector Switch 2

This three-position switch these
functions for your freezer.
operates the beater only (no refrigera-
tion to the cylinder). Always use this
mode when performing cleaning and
sanitizing operations.
position the beater motor and refrig-
eration system will not operate.
5.3 Reset — Overload
If the overload trips frequently, your
freezer should be checked for proper
product temperature, overrun and
voltage. Contact your Electro Freeze
Distributor.
5.4

"ADD MIX" Indicator Light 4

If proper mix level is not maintained,
a freeze-up may occur and may
damage the freezer.
12
a. "CLEAN" (left) — This position
b. "OFF" (center) — In this
Important:
Important:
continued)
Do not use the "AUTO" position with
water or sanitizer in the cylinder or
hopper. The freezer will be damaged.
c. "AUTO" (right) — This position
activates both the beater motor and
refrigeration unit. This is the normal
operating position. Unit needs 12 seconds to
internally set controls and start.
NOTE: 12 second reset time is required
anytime switch is turned from "OFF" to "Auto".
3
This control protects the beater motor
against failure from an overload condi-
tion by automatically shutting down the
freezer. To restart the freezer properly,
turn the SELECTOR switch to "OFF",
wait 2-3 minutes, then depress the red
reset button and turn the SELECTOR
switch back to the "AUTO" or "CLEAN"
position.
When blinking, this light indicates the
mix in the hopper is at a low level and
should be refilled as soon as possible.
Always maintain at least 2 inches (5.1
cm) of mix in the hopper. For best
operating results, keep hopper full.
Important:
184599