Latched Manual - EWM tigSpeed continuous drive 45 hotwire Operating Instructions Manual

Design and function
Transport and installation

5.1.15.3 Latched manual

This operating mode differs from non-latched operation in the following ways:
•
Wire feeding is started by pressing and releasing (tapping) BRT 2.
•
By tapping you can switch to the reduced wire feeding.
•
By pressing and releasing (tapping) BRT 2 again, wire feeding will stop. (It is not necessary to keep
the torch trigger pressed. This is especially helpful with long welding seams.)
Stopping the welding process:
•
Keep BRT 1 pressed for a period longer than the set tapping time.
The wire feeding can be stopped prematurely by pressing BRT2.
For this, the parameter "3-stroke" must be activated > see 5.2 chapter.
48
Figure 5-25
099-000236-EW501
25.04.2019