Vent Coolant Circuit - EWM tigSpeed continuous drive 45 hotwire Operating Instructions Manual
Wire feed unit
Hide thumbs
Also See for tigSpeed continuous drive 45 hotwire:
- Operating instructions manual (57 pages) ,
- Operating instructions manual (75 pages) ,
- Operating instructions manual (67 pages)
Table of Contents
Advertisement
Rectifying faults
Vent coolant circuit
7.4
Vent coolant circuit
To vent the cooling system always use the blue coolant connection, which is located as deep as
possible inside the system (close to the coolant tank)!
Complete the following steps to vent the welding torch:
•
Connect the welding torch to the cooling unit
•
Switch on the welding machine
Venting the welding torch starts and lasts for approx. 5 to 6 minutes.
60
Figure 7-2
099-000236-EW501
25.04.2019
Advertisement
Table of Contents
Need help?
Do you have a question about the tigSpeed continuous drive 45 hotwire and is the answer not in the manual?
Questions and answers