Installing The Electronics Unit In The Rack; Figure 3-3 Inserting A Battery Pack Into The Battery Box - HP PowerTrust A3589A Manual

Installing the UPS
Rackmounting Procedures

Figure 3-3 Inserting a Battery Pack into the Battery Box

Installing the Electronics Unit in the Rack

1. Install two rails just above the Battery Box. Four clip-nuts are needed and should be
placed in the 24th hole up from the bottom of each cabinet side frame rail.
2. Four clip-nuts are needed to secure the Electronics Unit. From the front of the cabinet,
place two clip-nuts in each front cabinet rail — one in the 32nd hole and one in the 41st
hole up from the bottom of the rail. See Figure 3-4.
3-6 Chapter 3