Attaching Front Bezel - HP PowerTrust A3589A Manual

3. Slide the Service Bypass Unit onto the shelf of the Electronics Unit until the connector
at the back of the Electronics Unit is aligned with the connector on the Service Bypass
Unit.
4. Carefully push the Service Bypass Unit into the cabinet until the connector is fully
engaged.
5. Secure the Service Bypass Unit to the rear cabinet frame with four screws.
6. Set the output receptacle cover (that came in the box with the Service Bypass Unit)
aside. You will attach it after you plug in the output receptacles.

Attaching Front Bezel

1. Attach one bracket to each of the four front corners of the Electronics Unit and secure it
with a single M4-.7 Torx screw. The alignment pins on each bracket must line up with
small holes in the front panel. (See Figure 3-6).
2. Position the front bezel onto the brackets so that the pins behind the front of the bezel
line up with the four brackets on the face of the Electronics Unit.
3. Gently push the bezel in until the bezel pins snap into the bracket clips.
4. Install nine filler panels onto the front of the cabinet rack below the Electronics Unit to
cover the Battery Box.
Chapter 3
Installing the UPS
Rackmounting Procedures
3-9