2 Connecting and installing the HP
D2D Backup System
In this chapter:
• "Connect the
• "Supported network
• "Software installation, discovery and
• "Web browser
Connect the hardware
1. Network connector
2. Power connector
Figure 5 Network and power connectors
1.
Always use the supplied power cord to connect the HP D2D Backup System to the main power
supply. This HP-approved cord is appropriate for your specific geographic region.
For detailed safety information, see the Safety Guide on the HP StorageWorks CD-ROM.
2.
Use the supplied network cable to connect to a Gigabit network switch. 100 Base-T Ethernet will limit
performance; 10 Base-T Ethernet will severely limit performance. For example network topologies,
see
"Supported network
hardware" on page 23
configurations" on page 24
settings" on page 26
configurations" on page 24.
configuration" on page 26
D2D Backup System
23