Log-Only Messages - HP PowerTrust A3589A Manual

HP-UX UPS Monitor Error Messages

Log-Only Messages

Log-Only Messages
The messages in this section are not displayed, but instead are logged in the syslog file.
See the syslog(3C) man page for more information.
MESSAGE
ups_mond: warning - no upstty: UPS's found in configfile
<filename>; daemon running for no purpose
SEVERITY Warning. May indicate an incorrect system configuration. PowerTrust units
that are supposed to be monitored are NOT being monitored.
MEANING The UPS Monitor successfully started execution and acquired system
resources, but then could not find any PowerTrust hardware units configured.
Although the UPS Monitor has no PowerTrust units to monitor, it will
continue running to inhibit excessive respawns out of /etc/inittab.
CAUSE If PowerTrust units are supposed to be on the system, either the PowerTrust
configuration is incorrect, or the PowerTrust cabling is not connected.
ACTION 1. If PowerTrust units are supposed to be on the system, correct the
2. Check the I/O hardware components that comprise the
3. Check the PowerTrust hardware for correct cable connections,
A-20
PowerTrust configuration file.
communications link from the SPU to the PowerTrust unit.
power-on/off condition, and front panel conditions.
Appendix A