Raven SmarTrax Installation Manual page 14

Chapter 3
Engage Switch Harness Routed into Cab
FIGURE 5.
Route the engage switch cable through the access point in the center of the cab, under the cab air filter.
6.
Cable Connector Reinstalled
FIGURE 6.
Reinstall the engage switch cable connector and pins, ensuring the pins are reinstalled into the correct
7.
cavity.
Node Harness Connected to Engage Switch Harness
FIGURE 7.
Locate the ENABLE connector on the node harness and connect it to the engage switch harness.
8.
10 MacDon M150, M155, M200, and M205 Series Windrower SmarTrax™ Installation Manual