Raven SmarTrax Installation Manual page 20

C 3
HAPTER
FIGURE 13. Viper 4 Connection
4. Connect the 12-pin connector of the CNH ISOBUS display adapter cable to the machine's mating connector
located behind the trim in the right-rear corner post of the cab
5. Locate the Viper 4 VT to SmarTrax adapter cable (P/N 115-4001-243).
6. Connect the TO SMARTRAX connector of the Viper 4 VT to SmarTrax adapter cable to the round 16-pin
connector of the SmarTrax node harness cable (P/N 115-4001-250).
FIGURE 14. Adapter Cable Routing
7. Route the Viper 4 VT to SmarTrax adapter cable behind the trim in the rear of the cab.
8. Connect the TO AUX PORT connector of the Viper 4 VT to SmarTrax adapter cable to the mating connector on
the Viper 4 to ISO VT adapter cable.
9. Connect the 3-pin power connector to the machine's accessory power plug located behind the operator's seat.
10. Install the terminators (P/N 063-0172-369) on the 4-pin connectors of the Viper 4 VT to SmarTrax adapter
cable.
16
Case IH Steiger and New Holland T9.XXX - Steering Ready, Model Year 2016 & Newer SmarTrax™ Installation Manual