Raven SmarTrax Installation Manual page 18
Case ih steiger and new holland t9.xxx - steering ready, model year 2016 & newer
Hide thumbs
Also See for SmarTrax:
- Calibration and operation manual (156 pages) ,
- Operation manual (73 pages) ,
- Installation manual (59 pages)
Table of Contents
Advertisement
C
3
HAPTER
FIGURE 10. 3-Pin Power Connector
Machine's 3-Pin
Power and
Accessory Power
Connectors
6. Disconnect the 3-pin power connector from the machine's accessory power plug located behind the operator's
seat.
7. Install the power tee connector of the SmarTrax chassis harness between the 3-pin power connector and
accessory power plug.
8. Loop and tie-off the REMOTE SWITCH cable connection, securing it with plastic cable ties as necessary.
NOTE:
The REMOTE SWITCH connector is not used in the SmarTrax system. Ensure the cable is secured away
from moving parts and heat sources.
FIGURE 11. Viper 4 Connection
9. Optional for Viper 4 Only - To connect the Viper 4 to the implement ISOBUS:
a.
Connect the round connectors of the Viper 4 to ISOBUS cable (P/N 115-0172-421 - sold separately) to the
mating ports on the back of the Viper 4.
14
Case IH Steiger and New Holland T9.XXX - Steering Ready, Model Year 2016 & Newer SmarTrax™ Installation Manual
Advertisement
Table of Contents
