Node Mounting Locations - Raven SmarTrax Installation Manual

C 3
HAPTER
FIGURE 19. DGPS OUT Connected to Console Receiver Connection
Console
Cable
20. Connect the DGPS connector on the node harness to the GPS receiver.
21. Route the DGPS OUT connector on the node harness to the A-post at the front-right corner of the cab.
22. Connect the DGPS OUT connector to the Raven field computer's GPS receiver connection.

NODE MOUNTING LOCATIONS

FIGURE 20. Node Mounting
When choosing the location for the SmarTrax node, consider the following points:
• Mount the SmarTrax node inside the machine's cab on a flat, level surface for proper performance and cable
connection.
• One of the six numbered direction arrows on the node must be oriented in the direction of forward vehicle
travel, one arrow pointing straight up, and two of the arrows parallel to the ground.
NOTE: Make a note of the number of the arrow that is oriented in the direction of forward vehicle travel. This
number will be needed during the SmarTrax calibration process.
• The node mounting location must not create tripping hazards.
• Mount the node in a location where it will not be kicked or jarred during normal equipment operation.
• The location must allow cable routing to avoid crimping or damaging the cables or the node connections.
20 Case IH Patriot 4440, Model Year 2017 & Newer - Steering Ready SmarTrax™ Installation Manual
Direction Arrows
Any two arrows
must be parallel
with level ground
4
Console Receiver
Connection
DGPS Out
(Node Cable
Connection)
5
Mounting
1
Tabs
2
3