FIGURE 5. Node Harness Installed on Node
8. Install the two large, rectangular connectors of the node cable (P/N 115-4001-247) into the correct ports of the
node, tightening the bolts on the harness connectors to secure the connections.
NOTE:
The connectors should be facing the window.
9. Locate the ENABLE connector on the node harness and connect it to the foot switch cable connector.
10. Route the node cable into the fuse box and behind the operator's seat.
11. Connect the DGPS connector to the GPS receiver.
FIGURE 6. DGPS OUT Connector Routed Under Operator's Seat
12. Route the DGPS OUT connector out the right corner of the operator's seat base and under the right arm rest.
P/N 016-5032-041 Rev. A
CAB COMPONENT INSTALLATION
13