Install The Foot Switch; Install The Node Harness - Raven SmarTrax Installation Manual

Chapter 3
•
One of the six numbered direction arrows on the node must be oriented in the direction of forward vehicle
travel, one arrow pointing straight up, and two of the arrows parallel to the ground.
Note:
Make a note of the number of the arrow that is oriented in the direction of forward vehicle travel.
This number will be needed during the SmarTrax calibration process.
•
The node mounting location must not create tripping hazards.
•
Mount the node in a location where it will not be kicked or jarred during normal equipment operation.
•
The location must allow cable routing to avoid crimping or damaging the cables or the node connections.
•
Securely fasten the node using bolts or screws through at least two of the three mounting holes. When
mounted properly, the node should not become loose or rotate.

Install the Foot Switch

Foot Switch Installed
FIGURE 7.
Select a suitable location for the foot switch (P/N 063-0172-470) to be installed.
1.
Note:
The foot switch should be installed in a location where the operator has easy access to it and is
able to fully press the pedal.
Using the holes in the foot switch as a template, drill holes in the floor of the cab.
2.
Secure the foot switch to the floor by installing the supplied screws in each of the mounting holes.
3.
Route the cable connector behind the operator's seat.
4.

Install the Node Harness

Install the two large, rectangular connectors of the node harness (P/N 115-4001-068) into the correct ports
1.
of the node, tightening the bolts on the harness connectors to secure the connections.
Locate the ENABLE connector and connect it to the foot switch cable connector behind the operator's seat.
2.
10
Case IH Puma and New Holland T70X0/T7.XXX - Steering Ready SmarTrax™ Installation Manual