Configure Settings - Primex XR Classic Series Install Manual

Configure Settings

Access setting panel
To change the factory default settings, remove the small rectangular access panel located in the upper center of the face of the
clock/timer. To aid in removal, there is a small recess in the top center of this panel. The panel can be removed with a small
screwdriver by gently prying the center top edge of the access panel forward. Setting changes can be made while the clock/timer
is ON and changes take effect within a few seconds.
NOTE
When power is first applied to the clock/timer or the reset button is pushed, a decimal point flashes for approximately
three minutes while the clock/timer receiver is turned on to search for a Transmitter signal. If the clock/timer does not
receive a valid signal from a Transmitter for three days its colons will flash.
Set LED Dimmer Display
The LED Display is set to 100% by factory default.
Set Dimmer to 25%
To dim the LEDs by 25% for a 2.5" display set Dimmer 2 in the UP position and for a 4" display set Dimmer 8 in the up position, as
illustrated below.
Set Dimmer to 50%
To dim the LEDs by 50% for a 2.5" display set Dimmer 1 in the up position and for a 4" display set Dimmer 7 in the up position, as
illustrated below.
Set Dimmer to 75%
To dim the LEDs by 75% for a 2.5" display set Dimmer 1 and 2 in the up position and for a 4" display set Dimmer 7 and 8 in the up
position, as illustrated below.
11