Primex XR Classic Series Install Manual page 10

Pressing the
button...
RESET Holding the SET/CHANGE button for 3 seconds enters
the set state, which is indicated by " _ _:_ _ _ _" on the
SET/CHANGE
display.
The selected digit will blink.
Pressing SET/CHANGE again to select the next digit.
Code Blue Timer - Timer Switch Control operating specifications
The Timer Switch Control allows a use to halt a code blue event.
Pressing the
button...
DISPLAY Ignored
EXIT
Holding down DISPLAY for a minimum of four seconds shows the last code blue time.
RESET Ignored
SET/CHANGE
STOP/START Halts the code blue event count at the moment the button is
pressed.
INCREMENT
Count Up Mode
Running Mode
Count Down Mode
Holding the SET/CHANGE button for 3 seconds enters
the set state, which is indicated by " _ _:_ _ _ _" on the
display.
The selected digit will blink.
Pressing SET/CHANGE again to select the next digit.
Places display back in clock mode
Ignored
Ignored
Halted Mode
10