Primex XR Classic Series Install Manual page 32

12. Install drywall anchors (not supplied) to align with the four fastening holes located on the front of the clock assembly.
13. Mount the clock assembly to the junction box(es), using the screws supplied with the junction box and the #8 washers
(supplied).
14. Reconnect the circuit board power cord connector and the timer input connector that was disconnected in step 6.
15. Refasten the circuit board using the four screws previously removed.
16. Peel off the protective checker board film from the two strips of tape and attach the face plate to the clock assembly.
17. Secure the clock using the four mounting holes located on the front of the clock and fasten to the wall mounting surface
(supplied).
32
XR Classic Series Digital Clocks/Timers Install Guide