Code Blue Timer Operation - Primex XR Classic Series Install Manual

Digital clocks/timers

Hide thumbs Also See for XR Classic Series:

Table of Contents

Code Blue Timer Operation

A Digital Code Blue Timer is a multifunction digital clock and timer that integrates with an existing code blue system to effectively

time each event.

When a code blue event is invoked a relay/pulse is sent from the code blue system to the timer, which triggers it to begin

counting up. If a code blue active event is in effect it will take priority and a previous task will run in the background until the

code blue event has stopped.

Code Blue Timer operation

Code Blue Timer function is triggered by the input of the wired connection to a code blue system and the use of the timer

switch control allows a user to halt a code blue count event.

Upon receiving a code blue system input, the code blue timer immediately enters code blue mode and starts counting up from

00:00:00. Upon reaching 99:59:59, the timer will beep for 3 seconds.

Code blue mode is indicated by the colon, dash and decimal points not being lit (in both viewing and counting modes).

Any other counting events remain operational in the background.

Time duration of the last code blue event is stored in memory, and can be viewed until a new code blue event is triggered.

A code blue count can be halted by pressing the STOP/START button. Pressing either DISPLAY or RESET is ignored while in

code blue mode.

Triggering of the code blue input while a current code blue event is counting is ignored.

In the event of a power outage, its internal memory maintains the correct time for a minimum of one hour without power;

requires a minimum one hour of charging time.

NOTE

If the code blue counter reaches 99:59:59 the counter will stop.

Timer Switch Control specifications

Designed to fit inside a single gang box (not supplied); typically 2 1⁄4 in. x 2 3⁄4 in. x 4 in. (11.45 cm x 6.99 cm x 10.15 cm).

Timer Switch Control can simultaneously activate two connected timers for even more accurate event management.

Timer Switch Control membrane switch and wall plate clean easily and resist common cleaners and disinfectants. Be sure to

test any cleaning solutions on a small area.

Code Blue Timer - Timer Switch Control operating specifications

The Timer Switch Control allows a use to halt a code blue event.

Pressing the

button...

DISPLAY

Ignored

EXIT

Holding down DISPLAY for a minimum of four seconds shows the last code blue time.

Running Mode

XR Classic Series Digital Clocks/Timers Install Guide

Halted Mode

Places display back in clock mode

Table of Contents