Primex XR Classic Series Install Manual page 9

Pressing the
Clock Mode
button...
STOP/START Ignored
INCREMENT
RESET Ignored
SET/CHANGE
Elapsed Timer - Set State operation specifications
The Set State is used to set the start time for a count up or count down event. Enter the Set State by holding the RESET button
while in count up or count down mode.
In this state:
The text labeled on the bottom of the switch control button is applicable (SET/CHANGE, INCREMENT, EXIT).
l
The dash, colon, and decimal points are not displayed.
l
The digit that is currently being set will flash.
l
Pressing the
button...
DISPLAY Exits Set State
EXIT
STOP/START Increments the selected digit
INCREMENT
9
Count Up Mode
Controls the count up event while in count up
mode.
If the count event is started, pressing and
releasing the STOP/START button stops and
pauses the event.
If the count event is stopped/paused, pressing
and releasing the STOP/START button resumes
the event.
Pressing and releasing the RESET button once
automatically stops and resets the count event
to its preset start time.
Or
Holding the RESET button puts the timer into
SET STATE.
Count Up Mode
Controls the count down event while in count
down mode.
If the count event is started, pressing and
releasing the STOP/START button stops and
pauses the event.
If the count event is stopped/paused, pressing
and releasing the STOP/START button resumes
the event.
Pressing and releasing the RESET button once
automatically stops and resets the count event
to its preset start time.
Or
Holding the RESET button puts the timer into
SET STATE.
Count Down Mode
Saves the start time and exits the Set State
Increments the selected digit
XR Classic Series Digital Clocks/Timers Install Guide
Count Down Mode