New Two-Tone CTCSS Pager Function
When using FTM-300DR/DE transceivers with a group of friends, setting the Two-Tone
CTCSS personal codes allows calling just the specific stations. Even when the person
who is called is not near the transceiver, the information on the LCD indicates that a call
was received.
The new two-tone CTCSS pager feature does not operate in digital mode. Press the [D X]
key to change from Digital to Analog FM or the AMS function.
Using the Pager Function
1. Press the [F(SETUP)] key [FUNCTION] [SQ-TYP]
2. Press the DIAL knob to select [PAG].
3. Press the [DISP] key or the PTT switch to save the setting and return to normal
operation.
Setting the Code for Your Station
Set the "pager code" to be called by other stations.
1. Activate the pager function (refer to "Using the pager function" above).
2. Press and hold the [F(SETUP)] key [SIGNALING] [2 PAGER CODE].
3. Rotate the DIAL knob to select [RX CODE 1] then
press the DIAL knob.
4. Rotate the DIAL knob to select the RX CODE 1 of the
code from 01 to 50.
5. Press the DIAL knob or the [BACK] key.
6. Rotate the DIAL knob to select [RX CODE 2] then
press the DIAL knob.
7. Rotate the DIAL knob to select the RX CODE 2 of the
code from 01 to 50.
The same code cannot be used for RX CODE 1 and
RX CODE 2.
Next, set the pager code for directing a call to a specific partner station.
8. Rotate the DIAL knob to select [TX CODE 1] then
press the DIAL knob.
12
SIGNALING
2 PAGER CODE
RX CODE 1
05
RX CODE 2
47
TX CODE 1
05
TX CODE 2
47
SIGNALING
2 PAGER CODE
RX CODE 1
05
RX CODE 2
47
TX CODE 1
05
TX CODE 2
47
SIGNALING
2 PAGER CODE
RX CODE 1
05
RX CODE 2
47
TX CODE 1
05
TX CODE 2
47