Yaesu FTM-300DR Advance Manual page 19

4. Rotate the DIAL knob to select [MEM] then press the
DIAL knob.
• " ", "L1" and "L2" blink.
«
• If you do not have the latitude and longitude informa-
tion, you cannot register the location.
5. Rotate the DIAL knob to select the mark to which you want to register the position
information.
6. Press the DIAL knob.
The location information is registered with the selected mark and navigation starts.
7. Press the [DISP] key return to normal operation display.
If you select [
operation when the location information of the partner station is displayed, you can register
the current latitude and longitude of the partner station as the destination.
z Using the Back Track Function
1. In the Real-Time Navigation screen, press the [F(SETUP)] key.
2. Rotate the DIAL knob to select the mark ([«], [L1] or [L2]) to which you want to
register the location information for back tracking.
Marks for which location information has not been registered are displayed in gray.
3. Press the DIAL knob.
• Navigation will start.
• The green point in the compass indicates the direc-
tion of the registration point (departure point), so if
you proceed so that the green point is always on
top, you can reach the registration point. (when the
compass is in heading up display).
4. Press the [DISP] key to end the navigation and return
to normal operation display.
z Description of the BACK TRACK Function Screen
Registration date and time
HUP: Heading up
NUP: North UP
Distance to destination
] (Display of other station) in step 2 above and perform the registration
19
Direction to destination
Heading of your station