Copying The Radio Data To Another Transceiver - Yaesu FTM-300DR Advance Manual

Copying the Radio Data to another Transceiver

The memory channels and settings in the set-up menu can be copied to another FTM-
300DR/DE. This is convenient when matching the settings of fellow stations that you
communicate with frequently.
1. Turn both transceivers OFF.
2. Connect the optional clone cable "CT-166" to the DATA
jack on the back of the main bodies.
3. Turn both transceivers ON.
4. Press and hold the [F(SETUP)] key  [CLONE]
5. On the transceiver from which data is to be copied,
rotate the DIAL knob to select [1 This  Other], then
press the DIAL knob.
The confirmation screen appears.
6. On the transceiver to which data is to be copied, rotate
the DIAL knob to select [2 Other  This], then press
the DIAL knob.
The confirmation screen appears.
7. On the transceiver to which data is to be copied, rotate the DIAL knob to select [OK],
then press the DIAL knob.
8. On the transceiver from which data is to be copied, rotate the DIAL knob to select
[OK], then press the DIAL knob.
The data transfer begins.
When data transfer is complete, "Completed" appears.
9. Press the [DISP] key or the PTT switch return to normal operation display.
10. Turn both transceivers OFF, then disconnect the clone cable.
• When "ERROR" appears on the screen during the clone operation, the operation has not
completed. Check the clone cable connection, and then repeat the procedure from the
beginning.
• If the clone operation is terminated due to a power loss during the data transfer, the
transceiver to which the data is copied will be reset automatically. Check the power supply,
cables and connections, then repeat the procedure again from the beginning.
30
CLONE
1 This → Other
2 Other → This
CLONE
1 This → Other
2 Other → This