Blower Section; Removing Band Complete L/R And Cushion - Makita EB5300TH Repair Manual

4-2

Blower Section

4-2-1

Removing Band complete L/R and Cushion

As for the REPAIR WORK of Cam gear, Muffler, Air cleaner plate, Carburetor, Insulator and Ignition coil, refer to
4-5-1.
Fig. 6
[1]
Fig. 7
[1]
Fig. 8
1
[1]
2
1
Release Buckle [1] on Band complete from the top of
Frame as follows: with a tool such as long-nose pliers,
turn Buckle 90 degrees, then pull it out through the slot
of Frame. Release the other three Buckles from the
[1]
bottom of Frame in the same way.
2
Lock rivet [1] fastening Band complete to Frame can
be removed by turning the center lock pin [2] of the
rivet counterclockwise with a Phillips screwdriver to
lift up the pin.
[2]

If the center lock pin [2] spins freely and cannot be
lifted up, turn the pin while lifting up Band complete
as shown on the left. (Remember this tip also when
removing Cushion.)

Lock rivet [1] can be removed from Band complete.
If it is removed, however, be careful not to lose the
center lock pin [2] because the pin will become easy
to fall off and get lost.
3
Remove Cushion [1] from Frame by removing four
Lock rivets [2] with a Phillips screwdriver; first
1
remove the two rivets indicated by arrow 1, then
remove the two indicated by arrow 2.
[2]
2
7 / 71
Tips