Table of Contents
Advertisement
Adjust the length of the hanging band as necessary.
Fig.16
6.
Insert the plug of the machine into the socket of
the portable power pack.
When inserting the plug into the socket, align the trian-
gle markings on both the plug and the socket.
2
Fig.17
► 1 . Plug 2. Socket 3. Triangle marking
NOTICE:
When disconnecting the plug and
socket, do not hold the cords but hold the plug
and socket. Otherwise, the cords may be damaged
and cause a malfunction of the unit.
7.
Press the main power switch to turn on the machine.
The machine is ready to operate. The machine will run
when you pull the switch trigger.
NOTE: Attach the cord of the machine to the cord
holder of the waist belt as shown in the figure (for
PDC1500 only).
Fig.18
► 1 . Cord holder
Blower operation
CAUTION:
ground while it is switched on. Sand or dust may
enter from suction inlet and cause a malfunction or
3
personal injury.
NOTICE:
recoil to the operator may be large when using the
machine due to the high air force of this product.
Adjust the air speed to an appropriate level when
using the machine.
Hold the machine firmly with a hand and perform the
blowing operation by moving it around slowly. When blow-
ing around building, big stone or vehicle, direct the nozzle
1
away from them. When performing an operation in a
corner, start from the corner and then move to wide area.
Fig.19
12 ENGLISH
Do not place the machine on the
Depending on the attached nozzle, the
1
Advertisement
Table of Contents
