Key Points Of Completion Inspection - Makita EB5300TH Repair Manual

4-6

Key points of completion inspection

(1) All parts and fasteners should be securely assembled.
(2) Cold engine should be started by pulling Recoil starter 5 or less times.
(3) Engine should be smoothly accelerated after two minutes idling.
(4) Engine speed should be 2600-3000min
* Be sure to check engine speed with 1R070, and with End nozzle 90-62 (nozzle diameter: 61.5mm) on
Intermediate pipe. Without the nozzle, engine speed cannot be increased.
(5) After assembly, make sure that Swivel of
Rotor hits Stopper (as shown) both at
idling and maximum output, and that
engine speed reaches the range described
above in (4).
Adjust Adjust screw, if Throttle of
Carburetor does not move to the full
throttle or idling position even though you
operate Throttle lever in the condition of
"assembly completed", which indicates,
in the case of Model EB5300TH, that
Control lever is installed on Swivel pipe
with no twist in Control cable.
(6) After assembly is finished, make sure that Throttle lever B (EB5300T)/Throttle lever (EB5300W) can be
locked in the full throttle position.
* If the lever cannot be locked and returns to the initial position, carry out adjustment by retightening the lever
locking bolt properly.
(7) Engine should always stop with operation of Stop switch.
(8) Hot engine should be restarted by pulling Recoil starter 5 or less times.
(9) There should be no fuel or oil leak.
(10) If Pipes and Nozzle are too tight, apply commercial a silicone lubricant spray to them.
-1
at idling and more than 6200min
Adjust screw
65 / 71
-1
at maximum output.
Fig. 155
Swivel of Rotor
Carburetor