Removing Frame, Compression Spring 22 (Damper Spring), Fan 243 And Front Volute Case - Makita EB5300TH Repair Manual

4-2-2 Removing Frame, Compression spring 22 (Damper spring), Fan 243 and Front volute case

Fig. 9
[1]
Fig. 10
[3]
Fig. 11
[2]
[3]
[1]
[2]
[2]
[1]
[1]
1
Remove Frame by removing six M5x16 Hex socket
head bolts [1] as shown on the left.

To prevent the engine section from falling down, put
the machine on a workbench with the Recoil starter
side down.

In the case of 5300WH, before removing Frame [2],
it is necessary to disconnect Control cable and Lead
unit from the engine section and to remove Control
arm. (Refer to 4-4-3.)

Do not fail to remove the two bolts fastening Fuel
tank.
2
Remove four Compression springs 22 (damper springs)
[1] by turning them counterclockwise.
Two different Compression springs 22 are used:

Two black ones [2] on the Cushion side of Frame

Two silver ones [3] on the bottom side of Frame
Be careful not to mix up the two springs.
3
Remove ten 5x20 Tapping screws [1] to remove Rear
volute case [2]. Elbow [3] is removed at the same time.
Remove the screws located on both sides of Elbow [3]
last of all to prevent Elbow [3] from falling down.
8 / 71
Note
Note
Note