Makita EB5300TH Repair Manual page 50

Fig. 110
[1]
[2]
Fig. 111
5
[3] 7
8
3 1
2 4
[2]
Fig. 112
[1]
Fig. 113
[1]
[2]
[3]
14
Insert the assembly of Crankshaft [1] and Piston into
Cylinder block [2].
15
Carefully set Crankcase [1] on Cylinder block, and
then fasten them by tightening four M6x20 Hex socket
head bolts [2] and four M5x20 Hex socket head bolts
6
[3] in numerical sequence as shown on the left.
[1]
16
Put Reed valve [1] on Crankcase. U-shaped notch of
the valve must be aligned with the rib of Crankcase.
17
By tightening M5x20 Hex socket head bolt [1],
assemble Retainer plate [2], Oil case gasket [3] and
Reed valve to Crankcase.

Oil case gasket [3] can be reused for replacement.

Tighten Oil case fastening bolts temporarily as a
positioning tool for Oil case gasket [3].
50 / 71
Tips