Assembling Recoil Starter - Makita EB5300TH Repair Manual

4-3-3

Assembling Recoil starter

Fig. 28
[3]
[1]
2
Wind the other end of Starter rope on Reel, leaving approximately 200mm unwound.
Fig. 29
[1]
[2]
Fig. 30
[1]
[2]
a
a
[3]
14 / 71
1
Pass one end of Starter rope [1] through Starter knob
[2] and Rope stopper [3], and then tie a knot in the end
of the rope.

Be sure to wear leather gloves to protect your hands.

Face the protruding side of Rope stopper [3] towards
Starter knob [2].

Tie the knot in Starter rope [1]. Each length (a)
should be approximately 10mm.
3
Put Reel [1] into Recoil starter [3]. When assembling
them together, be sure to look in the center hole of Reel
[1] to engage the inner end of Spiral spring [2] with the
hook of Recoil starter [3].
4
Install Friction spring, and then fasten Collar and
Swing arm assembly to Reel with Set screw [1].
Note