Assembling Control Lever (For Model Eb5300Th) - Makita EB5300TH Repair Manual

4-4-2 Assembling Control lever (for Model EB5300TH)

Fig. 45
[3]
[1]
300mm
Fig. 46
[1] [2]
[3]
[4]
[7]
[5]
b
d
[6]
[4]
[2]
a
1R411
c
1
Route Lead unit and Control cable [1] through
Corrugated tube [2].
Using vinyl tape or the like, attach the male straight
terminal [4] of Lead unit to the back of the cover tube
of the female straight terminal [3]. And then insert the
two terminals into Corrugated tube [2] to route the two
lead wires at the same time.
Insert the two straight terminals into Corrugated tube
[2] from the end without the white marking, and insert
the barrel nipple end of Control cable [1] from the end
with the white marking.
2
Assemble Control lever by reversing the
disassembly procedure.
3
Install Leaf spring A [1] and Leaf spring B [2] so
that Throttle link [3].
4
Fix the lead wires [4] of Lead unit in the lead wire
holders indicated by (a).
5
The slack portion of the lead wires [4] of Lead unit
should be put in the space indicated by (b) and (c).
6
Control cable [5] and Corrugated tube [6] should be
put in the space indicated by (d).
Make sure that Leaf spring A [1] and Leaf spring B [2]
are secured to Lever case [7] and they work properly.

Refer to 6 CIRCUIT DIAGRAM and 7 WIRING
DIAGRAM for wiring of the lead wires.

Fix lead wires into lead wire holders with 1R411.
21 / 71
Tips
Note
Note
Tips