Makita EB5300TH Repair Manual page 63

8
Install Recoil starter with three M5x20 Hex socket head bolts.
9
Attach Air cleaner element to Air cleaner case.
10
Fasten Air cleaner cover to Air cleaner case by tightening two M5x20 Thumb screws securely until they are
seated.
Fig. 153
2
[1]
2
12
Attach Band completes L and R to Frame by
pushing Lock rivet through each Band
complete into Frame.
Fig. 154
[1]
14
Install Control lever/Control handle on Swivel pipe, and then fasten with M5x30 Thumb screw.
15
Install Hose Clamp 100 and Cable holder.
16
By tightening Hose clamp 100, install Flexible pipe on Elbow.
[2]
1
1
63 / 71
11
Install Cushion [2] onto Frame by pushing four Lock
rivets [1] through Cushion into Frame.
Push Lock rivet into Cushion until the threaded portion
protrudes approximately 5mm above Cushion, then make
sure that all rivet legs are closed, and then push into
Frame. When reusing Lock rivet, you may find that one or
two rivet legs are not closed. If you push in the rivet
without closing the legs, the legs will be broken.
Band completes L and R are not interchangeable. When
you wear them correctly, the black edging of each Band
complete is positioned on the outside.
13
Match the short side of Buckle [1] to the slot of Frame,
then insert Buckle (6 pcs) [1] through the slot, and then
turn Buckle [1] 90 degrees.
Note
Note