Connecting Control Cable To Blower Body (For Model Eb5300Th) - Makita EB5300TH Repair Manual

4-5-14 Connecting Control cable to Blower body (for Model EB5300TH)

Fig. 145
[2]
[1]
Fig. 146
[1]
[2]
Fig. 147
[3]
Fig. 148
[1]
[3]
[3]
[1]
[2]
[2]
61 / 71
1
Pass the barrel nipple of Control cable through Adjust
screw [1]. Then turn Throttle [2] clockwise and hold it
with finger, and then attach the barrel nipple to Swivel
[3].
Note the orientation of Swivel [3]. If it is oriented wrong,
the barrel nipple cannot be attached.
2
Connect two Straight terminals [1] of Lead unit with
those from Ignition coil and Earth terminal, and then put
the terminals and Corrugated tube [2] in the space of
Front volute case [3].

Position Corrugated tube [2] so that the end face of
the tube is aligned with the marking (indicated by the
red dotted line) on Front volute case.

Be careful not to twist the cable.
3
Fix Control cable [3] in Clamp (2 pcs) [2] by tightening
4x14 Tapping screw [1].
4
By tightening two M5x16 Hex socket head bolts [1],
fasten Fuel tank [2] to Frame.
Tips
Tips