Makita EB5300TH Repair Manual page 59

Fig. 138
[2]
[3]
[1]
Fig. 139
[1]
[2] [3]
Fig. 140
[1]
[2]
3
Fasten Rear volute case [2] to Front volute case by
tightening ten 5x20 Tapping screws [3] so that Elbow
[1] can be squeezed with the two volute cases.
4
Install four Compression springs 22 [1] on Rear
volute case.

Two different Compression springs 22 [1] are
used: Install two black ones on the Cushion side
of Frame and two silver ones on the bottom side
of Frame. Be careful not to mix up the two
springs.

When assembling Compression spring 22 [1] to
Spring holder B [2], be sure to rotate the spring
until the end face of the spring stops against the
stopper [3] of the holders.
5
Fasten Frame [2] to Rear volute case by tightening
four M5x16 Hex socket head bolts [1] into Spring
holder B.
59 / 71
Note