Makita EB5300TH Repair Manual page 38

Fig. 80
1R311
[1]
Fig. 81
1R311
[1]
[2]
Fig. 82
[1]
Fig. 83
[1]
6
With 1R311, remove two Cam lifters [1] and Pin 5
[2].
The left and right Cam lifters [1] are identical for
[2]
easy assembling ; however, when assembling them to
Pin 5 [2], be sure to install the one on your right first.
7
With 1R311, pull off Pin 5 [1] to remove Cam gear
[2].
Check the gear teeth for wear, and check the
flyweight for damage. Flyweight is normal if you can
push it in easily with finger and if it returns to the
initial position easily.
8
Remove Pulley [1] by turning counterclockwise
with an impact driver and Socket bit 15.
Tighten Spark plug CMR6H beforehand because this
operation takes advantage of the power of air in
Cylinder.
9
Remove Flange nut M10 by turning
counterclockwise with an impact driver and Socket
bit 14.
Flywheel [1] is not screwed to Crankshaft, but the
two parts are joined together via a taper connection.
38 / 71
Tips
Tips
Tips
Tips