Assembling Carburetor - Makita EB5300TH Repair Manual

4-5-6

Assembling Carburetor

Fig. 71
[2]
[3]
[6]
1
2
[1]
3
4
[5]
5
[4]
6
7
1R217
33 / 71
Assemble Carburetor by reversing the disassembly
procedure.
Clean up the parts with gasoline or the like, and then
blow away the gasoline with air duster gun or the like.
Do not blow air at a high pressure.
If Pump diaphragm [3] and Metering diaphragm [5] are
deformed/ hardened/ damaged/ corroded, replace them
with new ones.
While pressing down Lever [1], install Screw [2], and
then make sure that Lever [1] is movable.
Match the two holes of Pump gasket and Pump
diaphragm [3] with the positioning pins of Carburetor
body, and then install Pump body assembly [4] on
Carburetor body.
Match the two holes of Metering diaphragm gasket and
Metering diaphragm [5] with the positioning pin of
Pump body assembly, and then assemble Metering
diaphragm cover to Pump body assembly.
Adjust Adjust screw [6] so that the clearance is 1.0 to
2.0mm.
Note