Starter Unit - Makita PM7650H Technical Information

R
epair
[4] DISASSEMBLY/ASSEMBLY

[4]-11. Starter unit

DISASSEMBLING RECOIL STARTER
(1) Pull Starter rope out of Starter case complete approximately one winding long. Then hook Starter rope on
the U-shaped notch of Reel, then turn Reel clockwise until Spiral spring is unwound. (Fig. 48)
Note: Be careful with Reel because it will turn very fast.
(2) Remove two Swing arms and Reel by unscrewing 5x12 Tapping screw.
Note: Be careful with Spiral spring that can suddenly pop out of Starter case complete.
(3) Untie the knot of Starter rope to remove Starter rope from Reel. (Fig. 49)
Fig. 48
Starter case complete
Starter rope
ASSEMBLING RECOIL STARTER
(1) If Spiral spring pops out of Reel, put it back in place by setting
the outer end of Spiral spring in place in Reel first, then by winding
Spiral spring counterclockwise towards the center of Reel. (Fig. 50)
(2) Apply a little amount of Makita grease N No.2 to the whole surface
of Spiral spring.
(3) Put a new Starter rope through Starter case complete. (Fig. 51)
Then tie one end to Starter knob and the other to Reel by making
a knot as shown in Fig. 52.
(4) Wind Starter rope around Reel two or three times.
Fig. 51
Starter rope
Reel
Reel
Starter knob
U-shaped notch
Starter knob
Fig. 49
5x12 Tapping screw
Swing arm
(2 pcs)
Fig. 50
Reel
Fig. 52
about 10mm
P 17/26
knot of Starter rope
Reel
Spiral spring
about 10mm